Features and Benefits:

• 12,000 lb. Capacity
• Heavy Duty, Commercial Grade
• Extra Tall, Extra Wide & Extra Long
• Air Operated Single Point Lock Release (External Air Supply Required)
• Lock Ladder Design
• Double Lock Safety System
• Steel Approach Ramps Included
• Additional Drive off Ramps Available (Sold Separately)
• Mounting Hardware Included
• Alignment Kit, Slip Plates and Turntables Available (Sold Separately)
• 220volt/1phase Electric Operation (Requires a 30amp Breaker)
• Shipping Weight 3,000 lbs.
• 5 yr Structural ‐ 2 yr Hydraulic Warranty ‐ Parts Only
• Capacity: 12,000 lbs.
• Lifting Height, Top Lock: 68 1/2" (5' 8 1/2")
• Overall Width (w/ Motor): 141 1/2" (11' 9 1/2")
• Overall Length (w/ Approach Ramps): 253" (21')
• Runway Length: 205" (17' 1")
• Length Between Columns: 189 3/4" (15' 9 3/4")
• Runway Width: 20"
• Width Between Runways: 42 1/2" - 46 1/2"
• Outside Runway to Outside Runway: 62 1/2" - 66 1/2"
• Width Between Columns: 114 3/4" (9' 6 3/4")
• Drive Thru: 100" (8' 4")
• Height of Columns: 89" (7' 5")
• Clearance Under Runways, Top Lock: 61 1/2" (5' 1 1/2")
• Air Requirement: 85-115 PSI (EXTERNAL AIR SUPPLY REQUIRED)
• Electrical Requirement: 220V - Single (1) Phase - 30 amp breaker recommended
• Oil Requirement: 3-5 Gallons AW32/AW46 (NOT INCLUDED)
• Shipping Weight: 3,000 lbs.
• Requires a minimum of 6" of concrete with a 3000 psi. rating

The Atlas® Pro12K Heavy Duty Commercial 4-Post lift incorporates many structural and cosmetic features that are found on lifts costing thousands of dollars more money. The Atlas® Pro12K is tested to ensure that this lift system will perform flawlessly at its rated capacity.

The Atlas® Pro12K uses a high strength cable system (with an under runway oversized hydraulic cylinder) powered by a 220 volt (single phase) power unit to raise and lower the lift. Many competitors use an "old style" chain lifting system with an exposed hydraulic cylinder system. Old style chain lifts are difficult to "level" properly and the exposed hydraulic cylinder is responsible for numerous "door dings".

The Atlas® Pro12K comes pre-drilled to accept an alignment kit consisting of slip plates, spacers, ramps, and turntables (ALI KIT sold separately). The Pro12K also features "tracks" between the runways to allow the use of a rolling bridge jack (such as the Atlas® RJ6BK) on the lift (Rolling Jacks sold separately).